Pico Macom PCM55SAW - Technical Specifications; RF and Video Specifications; Audio and General Specifications; Ordering Information

PCM55SAW
355 Parkside Drive San Fernando, CA 91340
Ph: 818-
5
Rev. 09/02
Specifications
Ph:800-421-6511
www.picomacom.com
550MHz Single-Channel PLL SAW-filtered A/V Modulator
550 MHz PLL Saw-Filtered Audio/Video Modulator
PCM55SAW
OUTPUT LEVEL
AUDIO LEVEL
AURAL CARRIER
VIDEO LEVEL
CHANNEL
OUTPUT TEST
-30 dB
POWER
VIDEO IN
120VAC
60Hz 10W
600W MAX
AUDIO IN
RF OUT
Front View
Rear View
Channels: 90 Channels
(CATV T7-T13, 2-78, 95-99)
Frequency Range: 5.75-550 MHz
Output Level: 55 dBV min., 58 dBmV typ.
adjustable from front panel
Output Impedence: 75 Ohms
Output Return Loss: -15 dB
Audio/Video Ratio: Adjustable -7 to -22 dB
below video carrier
Frequency Stability: 10 (±5 kHz in aeronautical
band)
Spurious Output: 60 dB below video carrier
with A/V ratio @ -15 dB
C/N (In-Band): >60 dB
C/N (Out-of Band): >65 dB
Rejection: Fv - 1.5 MHz >-60 dB
Fv - 4.5 MHz >-63 dB
Fa + 1.5 MHz >-63 dB
Fa + 4.5 MHz >-63 dB
Input Level: 1.0 V p-p for 87.5% mod.
Input Type: Clamped video neg. sync
Frequency Response: ±1.5 dB, 0 Hz to 4.2 MHz
Differential Gain: <5% (10 to 90 % APL)
Differential Phase: <5% (10 to 90 % APL)
Hum and Noise: -60 dB @ 87.5% modulation
Video Signal to Noise: -60 dB minimum (weighted)
Input Level Range: 0.5 V p-p to 1.5 V p-p
Power Input: 120 VAC @ 60 Hz
Operating Temperature: -10°C to 50°C
Dimensions: 19˝(L) x 12˝(D) x 1
3
/4˝(H)
Weight: 9 lbs.
Connectors: “F” Type
Frequency Response: ±0.4 dB @ 50 Hz to 15 kHz
Harmonic Distortion: 0.5% @ 50 Hz to 15 kHz
Pre-Emphasis: 75 microseconds
Signal to Noise Ratio: 60 dB
RF
Video
Audio
General
PCM55SAW - Channel
Ordering Information