Pico Macom PFAM550SUB - Panels; Front and Rear Panel Components

PICO MACOM INC. 12500 Foothill Blvd. • Lakeview Terrace, CA 91342 • (818) 897-0028 • (800) 421-6511 • FAX (818)824-7197
P A N E L S
Front and Rear Panels
4
1. Power on LED:
Indicates power is on when lit.
2. Video/Audio Ratio adjustment:
Used to set level of audio carrier.
3. Audio Modulation LED:
Indicates aural over modulation level
when lit.
4. Audio Modulation adjustment:
Used to set audio modulation (Volume).
5. Video Modulation adjustment:
Used to set video modulation.
6. Video modulation LED:
Indicates video over-modulation when lit.
7. Channel Select:
Dip switches are used to select desired
channel.
8. RF Output Adjust:
Used to set output level.
9. -30dB Output test monitor:
Used to monitor RF output level.
10. RF Output:
Connect this port to distribution system.
11. I.F. Input:
Input from I.F. scrambler or I.F. output.
12. I.F.Output:
To I.F. input or to scrambling device.
13. Video Input:
Accepts video output from satellite
receiver, VCR and CCTV camera.
14. Audio Input:
Accepts audio output from satellite
receiver, VCR and CCTV camera.
15. SUB CATV:
When switch is in SUB position channels 7
to 13 are converted to T7 to T13. When
switch is in CATV position CATV channels
2 to 78 and 95 to 99 are available.
16. Fuse holder:
117VAC type - 0.5 amp, 125V slow-blow fuse.
220VAC type - 0.5 amp, 250V slow-blow fuse.
17. Convenience Outlet:
117VAC type - shown
220VAC type - 2 flat blade type (not shown)
18. Power Cord:
117VAC type - Three wire, standard U.S.A. type.
220VAC type - Two wire,2 flat blade type.
CAUTION: FOR CONTINUED PROTECTION AGAINST
FIRE HAZARD REPLACE ONLY WITH THE SAME
TYPE 1/2 A 125 V FUSE AND RATING OF FUSE.
PFAM 550SUB
AGILE VIDEO MODULATOR
AUDIO
MODULATIONAURAL
LEVEL ADJUST
VIDEO
MODULATION
ADJUST
OUTPUT
LEVEL
-30 dB
TEST POINT
RF OUT IF IF OUT VIDEO
IN
AUDIO
IN
250 VAC
0.5A
600VA MAX 117VAC
60 Hz 20 W
FUSE
1
2 3
4 5 6
CHANNEL
8 9
7
10
11 13
14 15 17
SUB CATV
1612