09
EN
Dispose of your headset and/or accessories in accordance with local regulations and
government advice. Do not dispose of the headset or accessories in the fire or
incinerator, as the battery may explode when overheated. Dispose separately from
household waste.
Please comply with the local laws and regulations on the disposal of the batteries and
the headset as an electronic device, at designated waste collection points and
separately from household waste.
Do not use high volume for extended periods of time to prevent possible hearing damage.
When using headphones, use the minimum volume required to avoid hearing
damage. Prolonged exposure to high volume may cause permanent hearing damage.
Do not use the equipment near fuel stations or hazardous areas containing flammable
articles and chemical agents. Follow all graphic or text instructions when in possession of
the product around these areas. Operating the product in these hazardous sites poses
risk of explosion or fire.
Do not store or transport the product or its accessories in the same container as flammable
liquids, gases, or substances.
Do not use the product when walking, cycling, driving, or situations that require full visibility.
Take caution if using the product as a passenger in a motor vehicle, as irregular movement
may increase the risk of motion sickness.
Environmental protection
Hearing protection
Flammable and explosive areas
Transportation safety
Charger safety
Battery safety
Only charging devices provided in the product package or specified as an approved device
by the manufacturer should be used.
When charging is completed, disconnect the charger from the equipment and unplug the
charger from the power outlet.
Do not operate the equipment, charger or cable with wet hands to avoid short circuits,
failure, or electric shock.
Do not use the charger if wet.
If the charging adapter or cable is damaged, discontinue using to prevent the risk of
electric shock or fire.
VR Headsets are equipped with non-removable internal batteries. Do not attempt to
replace the battery, as doing so may cause battery damage,fire, or human injury. The
battery can only be replaced by PICO or PICO authorized service providers.
Do not disassemble or modify the battery, insert foreign objects, or immerse in water
or other liquid. Handling the battery as such can cause chemical leakage, overheating,
fire, or explosion. If the battery appears to be leaking material, avoid contact with skin
or eyes.In case of material contact with skin or eyes, immediately rinse with clear water
and seek medical advice.
Do not drop, squeeze ,or puncture the battery. Avoid subjecting the battery to high
temperatures or external pressure, which may result in corruption and overheating of
the battery.
Do not connect the metal conductor with the two poles of the battery, or contact the
terminal of the battery, so as to avoid short circuit of the battery and physical injury
such as burns caused by overheating of the battery.
Please contact PICO or PICO authorized service providers to replace the battery when
the standby time of your device is obviously shorter than the normal time. Replacement
of a battery with an incorrect type may defeat a safeguard.
Do not use your product if any part is broken or damaged.
Do not attempt to repair any part if your product yourself. Repairs should only be made
by an PICO authorized servicer.
Do not expose your headset and controllers to moisture, high humidity, high concentrations
of dust or airborne materials, temperatures outside their operating range or direct
sunlight to avoid damage.
Keep your headset, controllers, charger, cables and accessories away from pets to
avoid damage.
VR Headset
VR Product Care
No Direction Sunlight on Lense
Controller
Disposal and recycling information
The crossed-out wheeled bin symbol on your product, battery, the literature or
packaging reminds you that all electronic products and batteries must be taken to
separate waste collection points at the end of their working lives; they must not be
disposed of in the normal waste stream with household garbage. It is the responsibility
of the user to dispose of the equipment using a designated collection point or
service for separate recycling of waste electrical and electronic equipment (WEEE) and
batteries according to local laws. Proper collection and recycling of your equipment helps
ensure electrical and electronic equipment (EEE) waste is recycled in a manner that
conserves valuable materials and protects human health and the environment, improper
handling, accidental breakage, damage, and/or improper recycling at the end of its life
may be harmful to health and environment. For more information about where and how
to drop off your EEE waste, please contact your local authorities, retailer or household
waste disposal service or visit the website https:// www.picoxr.com
FCC statement
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to part 15 of the FCC Rules. These limifts are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a
particular installation.
If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
Note: The manufacturer is not responsible for any radio or TV interference caused by
unauthorized modifications to this equipment. Such modifications could void the user’s
authority to o perate the equipment.
FCC RF radiation exposure statement
This equipment complies with FCC RF radiation exposure limits set forth for an uncontrolled
environment. This device and its antenna must not be co-located or operating in conjunction
with any other antenna or transmitter.
US Regulatory Information
“Supplier’s Declaration of Conformity 47 CFR §2.1077 Compliance Information” SDoC
Website: https://www.picoxr.com/legal/compliance
Canada Regulatory Information
This device complies with Industry Canada license-exempt RSSs. Operation is subject to the
following two conditions:
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
operation of the device.
Caution:
PICO Product Limited Warranty
PLEASE READ THIS LIMITED WARRANTY CAREFULLY TO UNDERSTAND YOUR RIGHTS AND
OBLIGATIONS. BY USING YOUR PICO PRODUCT OR ACCESSORY, YOU AGREE TO THE
LIMITED WARRANTY.
PICO issues this warranty to you, as a consumer who has purchased a new, covered product
from PICO or an authorized retailer (“you”). This warranty is not available to products that
were purchased from any source other than PICO or an authorized retailer.
What Does This Warranty Do?
This Warranty gives you specific legal rights, and you may also have other rights which vary
from country to country. This Warranty is in addition to and does not affect any rights you
have under the laws in your jurisdiction concerning the sale of consumer goods.
The device for operation in the band 5150–5250 MHz is only for indoor use to reduce the
potential for harmful interference to co-channel mobile satellite systems;
The high-power radars are allocated as primary users (i.e. priority users) of the bands
5250-5350 MHz and 5650-5850 MHz and that these radars could cause interference
and/or damage to LE-LAN devices.
DFS (Dynamic Frequency Selection) products that operate in the bands 5250- 5350 MHz,
5470-5600 MHz, and 5650-5725 MHz.
The exposure standard for wireless transmitter employs a unit of measurement known as
the Specific Absorption Rate, or SAR. The SAR limit set by the IC is 1.6W/kg.
The highest SAR value for the EUT as reported to the IC when tested for use is1.55 W/kg.
This equipment may be operated in
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into on outlet on a circuit different from that to which the
receiver is connected.
Consult the dealer or an experienced radio/ TV technician for help.
This device may not cause harmful interference.
This device must accept any interference received, including interference that may
cause undesired operation. Any changes or modifications not expressly approved by
the party responsible for compliance could void the user’s authority to operate the
equipment.
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
To Next Page
Loading...
Need help?
General
