44
45
pico c instruction manual
You can optionally change a beer's alcohol percentage
and bitterness from the PicoPak defaults. To do so,
turn Control Knob to the right when screen says “Start
Brewing”. This will give you the ability to adjust the
alcohol and bitterness. Once finished, you can select
Start Brewing by pressing the Control Knob and your
brew session will begin.
Note: This option is only available for select PicoPaks
at this time.
₆
Pico will begin brewing and complete in
approximately 2-3 hours, depending on the beer
recipe and any adjustments you might have made.
You do not need to monitor the Pico during the brew
session.
Notes:
• You can track the progress by signing in at
www.PicoBrew.com and clicking on BrewHouse.
• It is normal for only a small amount of liquid to
show in the bottom of the Step Filter during
brewing. If the Step Filter is more than a third
full of liquid during brewing, end the brew
immediately and contact info@picobrew.com.
• Pico heats the water using steam, and
occasional hissing or growling noises are
normal. Don't worry, Pico is not upset, only
heating!
• If your PicoPak is not recognized by your Pico, it
can still be brewed! Enter the serial number of
the PicoPak at www.PicoBrew.com/Members/
Support/PicoPak to associate it to your
account.
:
₇
unboxing setup
first
rinse
let's
brew
after
brewing
ferment
your beer
dry
hopping
rack &
carbonate
serving
usage &
care
sous vide glossary
To Next Page
Loading...