pigtronix INFINITY 2 - Loop 1 Footswitch; Loop 2 Footswitch

5
Press to record.
Press again to close the loop.
Press again to start overdub at the beginning of the next loop cycle.
Double-tap to stop.
Double-tap and Hold to erase.
Long-press on initial record sends Loop straight to overdub when closed.
When a loop has been recorded but is stopped, pressing the Loop 1 footswitch will resume playback
from the beginning of the loop.
The pair of loops in the Infinity 2 are set to play in series for Verse/Chorus type arrangements.
The Loop 2 footswitch controls the looping actions for Loop 2, and functions the same way as the
Loop 1 footswitch (see above).
Pressing Loop 2 while Loop 1 is recording will cause Loop 1 to close and Loop 2 to begin recording
or playback immediately.
Pressing Loop 2 while Loop 1 is playing back will cause Loop 2 to begin recording or playback at the
end of Loop 1.
Pressing Loop 2 while Loop 1 is overdubbing will cause Loop 2 to begin recording or playback at the
end of Loop 1.
Pressing and holding the Loop 2 footswitch during initial recording will send Loop 2 straight into
overdub when the loop is closed.
All of these same rules apply to Loop 1.
It is possible to cancel a pending transition between loops by pressing the footswitch of the
currently playing loop.
LOOP  FOOTSWITCH
LOOP  FOOTSWITCH