7
STOP
Press to Stop at the end of the loop cycle.
Double-tap to Stop instantly.
Press and Hold to fade out.
Double-tap and Hold to Erase.
Press STOP during initial record to prevent playback when recording is closed.
ONCE
Press to restart the current loop for single-shot playback.
Press repeatedly for stutter.
Press and Hold for continuous playback.
ONCE can be used to start initial recording on Loop 1.
If ONCE has been used to start initial recording on Loop 1, closing the loop using the ONCE footswitch
will cause one time playback.
If ONCE has been used to start initial recording on Loop 1, closing the loop using the Loop 1
footswitch will close the loop, but will not play back. This lets you record a loop, and save it for later.
OCTAVE
Press to immediately switch sample rate to 24kHz.
Press again to immediately switch it back to 48kHz.
Press and Hold to change sample rate at the end of the loop cycle.
Note: Default Sample rate is 48kHz.
Note: The small red Octave LED will blink when the sample rate is switched to 24kHz
Note: Sample rate can be changed during initial recording or overdub.
Note: STOP, ONCE and OCTAVE functions can still be selected when UNDO / REDO mode has been
turned on.
Audio recorded at the default sample rate of 48kHz will play back one octave down when the sample
rate is changed to 24kHz.
Audio recorded at 24kHz will play back one octave up when the sample rate is changed to 48kHz.
To Next Page
Loading...
