pigtronix INFINITY 2 - USB Firmware Update

9
A micro USB port is provided for future firmware updates.
Check for firmware updates and the Infinity 2 Updater for PC here: www.pigtronix.com/Infinity2
In order to update the firmware on the SPL2, simply connect the unit to a PC with the proper micro
USB connector cable. Right-click and choose Run as Administrator to launch the application. Click
”Refresh List” then select Infinity 2 from the ”Hardware List” drop-down menu. Select the firmware
to upload and then click the Update Firmware button. The unit will then automatically reboot with the new
firmware loaded. DO NOT disconnect the power to the Infinity 2 during the firmware update process.
USB FIRMWARE UPDATE
If there is no audio recorded on Loop 1, pressing the Loop 1 footswitch will begin recording immediately.
Once the loop is recording, pressing the Loop 1 footswitch again will close the loop and begin playback.
When recording on Loop 1, pressing the Loop 2 footswitch will close Loop 1, and will simultaneously
begin recording or playback on Loop 2.
During playback, pressing the Loop 1 footswitch will open an overdub layer on Loop 1 starting at the
beginning of the next loop cycle.
Once an overdub is recording, pressing the Loop 1 footswitch again will close that overdub layer
immediately.
Closing an overdub with a long press will cause the overdub to close at the end of the current loop cycle.
Pressing and holding the Loop 1 footswitch during initial recording will send Loop 1 straight into
overdub when the loop is closed.
Pressing and holding the Loop 1 footswitch during Loop 2 playback will send Loop 1 straight into
overdub at the loop boundary.
When recording an overdub, the overdub will not save until it is closed and a loop boundary has
been passed.
Pressing the loop footswitch during an overdub will close that overdub.
Aer closing an overdub you can choose to reopen it by pressing the loop footswitch as long as the
loop cycle hasnt ended yet.
At the end of the loop cycle, all audio recorded during that cycle is merged and saved as a single overdub.
RECORDING
OVERDUB