4.3 Clean with a Chemical Agent
CAUTION
DO NOT USE CLEANING AGENTS THAT ARE NOT RECOMMENDED. IF YOU DO,
YOU CAN CAUSE DAMAGE TO THE WINDSHIELDS AND WINDOWS.
CAUTION
WHEN YOU CLEAN VERY DIRTY AREAS, DO NOT USE EXCESSIVE PRESSURE. IF
YOU DO, YOU CAN DAMAGE THE PAINT TOP COAT.
1 Use a spray bottle to apply the cleaner (example - Extreme Simple Green cleaner)
directly onto the surface.
2 Leave the cleaner on the surface for a maximum of three minutes.
3 Use the soft bristled brush to clean the surface.
4 Flush the area with clean water.
5 If necessary, do steps 1 thru step 4 again until all the aircraft exterior surface is clean.
4.4 Requirements after Job Completion
1 Remove the covers from:
− The engine intake
− The engine exhaust stubs
− The angle of attack sensors
− The static ports
− The pitot probes.
2 Flight crew or authorized trained personnel - set the flaps to 0°.
3 Clean the aircraft windows.
4.5 Recommended procedures
Equipment
Recommended Pilatus Part Number
Grease 908.20.02.065
Local supply (Aeroshell 33)
Grease gun 904.21.02.103
904.21.02.104
904.21.02.102
904.21.02.702
904.21.02.110
Local supply
Note
It is the operators responsibility to provide applicable training in this procedure.
Section 2 - Aircraft Servicing
Ground Servicing Guide Report No: 02527
Issue date: Dec 19, 2022
Page 2-5-4
12-A-A15-20-0807-02A-254A-A
To Next Page
Loading...
