Pilot-1 Aeronca Champ - Page 6

6
5. Attach 24” servo wire extension to aileron
servo lead and secure with tape, heat shrink
tubing, or Graupner servo retaining clips
(p/n GR3503).
6. Break string loose from aileron servo bay
and tape to servo wire. Use this string to pull
wire through wing. Insert finished servo and
hatch cover into wing and secure with small
sheet metal screws.
7. Use tape to keep aileron servo wire from
falling into wing.
8. Locate the “CA” hinges bag. These will be
installed using thin CA glue.