7
9. Prepare the CA hinges by folding in half as
shown. This technique helps keep the
hinges centered during installation.
10. Trial fit aileron in place before gluing.
Careful attention should be placed on gaps
at ends of aileron.
11. With the aileron tight and deflected
downward, use 2 to 3 drops per hinge of thin
CA to assure strong bonds. Use paper towel
to remove any excess CA before it dries.
Then flip wing over and repeat for opposite
side of hinge, again 2-3 drops of thin CA per
hinge.
12. The Aileron Horn needs a hole to be drilled
through the aileron. Use a pen and straight
edge to mark aileron parallel to the hatch
cover slot.
To Next Page
Loading...