Pilot Communications BluLink - Directions

4
Directions
• Insert2AAalkalinebatteries.
• Plugthecordforheadsetintoheadsetlabeledjack.
• Plugthecordforintercom/panelintoairplanelabeledjack.
• ConnectheadsettoBluLink.
• ConnectBluLinktoaircraftpanelorintercomsystem.
• Turnunitonbypushingandholdingbuttonfor2seconds.
Green light will come on and then fade away.
• Toturnunitoff,pressandholdbuttonfor2secondsuntilred
light comes on.
Note: In the battery compartment are 2 switches. The top switch
(A) is a Mono/Stereo switch. If aircraft intercom system is Mono, put
switch in Right (2) Position. (If you hear from only 1 side of headset,
put switch in right (2) position.)
The bottom Switch (B) is for auto mute. When the switch is to the left
(1) BluLink will mute your music source when anyone, including ATC,
speaks over the intercom. When the switch is to the right (2) BluLink
will not mute the music source.