Ancillary Components Installation:
Check the correct location of your chosen battery depending on your
Check the correct location of your chosen battery depending on your
CG.
Glue Velcro strip to the battery tray (and battery), as well as threading a
velcro strap round the battery tray, assuring a completely secure
battery once fully installed.
Finally install your receiver with double sided tape or velcro, making
sure that all servo leads can be easily connected without being too tight,
and that the receiver is securely fixed in place.
For specific tips on receiver and antenna location, please consult your
receivers manual.
To Next Page
Loading...
