Servo Horn On The Ailerons Installing:
Servo Horn On The Rudder Installing:
It is very important to sand horn to assure a strong bond once glued to the
model.
Locate and cut the covering where the horns will be glued
Glue them to the surface using epoxy glue
Excess epoxy glue can be removed with acetone
It is very important to sand horn to assure a strong bond once glued to the
model.
Locate and cut the covering where the horns will be glued
Glue them to the surface using epoxy glue
Excess epoxy glue can be removed with acetone
To Next Page
Loading...
