INCLUDED HARDWARE:
• Complete air frame with all basic accessories (such as carbon fibre main
undercarriage, tail-gear assembly and wing-tubes as well as fibreglass
control horns and wheel pants)
• Included wing bags
• Included extension wires
• Pre-prepared hinges ready to be installed and pre-mounted canopy
• Fuel tank, fuel dot and fuel tubing pre-prepared
• Wheels, axels and wheel pants
• Pre-prepared pushrods with ball links
• Included spinner
REQUIRED HARDWARE:
Motor: 20cc or equivalent electric
*Please note that the setup of this plane allows both electric or gas engines,
however in order to use a gas engine, the firewall and engine box must be
reinforced.
Servos: 4 high torque plus throttle // Uses x1 per aileron, x1 for elevator and x1 for
rudder
*Please note that the servo slots are designed to accept a medium size servo (35mm
x 15mm) however the wood has been prepared and marked, should you wish to
enlarge in order to accept standard size servos.
Also requires all the usual accessories such as transmitter, receiver, propeller,
batteries, powerbox, extension leads and possibly other small accessories.
PILOT-RC RECOMMENDED HARDWARE:
• Servos: Pilot-Rc PW16AH (16Kg at 8,4v)
• Servo arms: Pilot-Rc 1,2″ Aluminium arms (included with Pilot-Rc servos)
• Electric Motor Combo: Pilot-RC Power Pack for 67″ plane (3D acrobatic)
• Electric Motor & Servos Combo: Pilot-
RC Power Pack for 67″ plane WITH servos (3D acrobatic)
OTHER ACCESSORIES NEEDED TO COMPLETE:
To Next Page
Loading...
