•
Slide the wheel pants over the wheels and axles, supporting the rear of the pants to
line up with the ground and mark where to drill the two screw holes in the wheel
pants.
Remove the wheel pants and drill the holes for the appropriate holes.
Before putting back on the plane, mount the bolt with the blind nut on the wheel
pant and tighten until the nut sits flush with the wheel pant.
Remove the bolts and the nuts should stay in place.
Slide the wheel pants back over the wheel and bolt in place.
SFG – SIDE FORCE GENERATORS:
If you choose to use the included SFG’s with quick release system, simply bolt these
to the wing-tips using the provided finger screws.
To Next Page
Loading...
