What to do if the motor thermal protection trips on my pilotair Air Compressor?
If the thermal relay of the main motor has tripped, and it doesn't automatically reset, you should manually reset it by pressing the reset key. Also, verify the absorbed current values and the calibration value.
How to reset the maintenance Group A light on my pilotair Air Compressor?
If the machine has reached the set number of working hours to carry out maintenance of the Group A, you should carry out the maintenance and then hold down the Reset key for at least 30 seconds.
How to reset the maintenance Group B light on my pilotair Air Compressor?
If the machine has reached the set number of working hours to carry out maintenance of the Group B, you should carry out the maintenance and then hold down the Reset key for at least 30 seconds.
What to do if the fan thermal protection trips on my pilotair Air Compressor?
If the fan motor protector has tripped, reset the contact by pressing the key on the board. Also, check the current values and the calibration value.
How to reset the emergency stop switch on a pilotair Air Compressor?
If the mushroom switch has been activated, release the emergency switch by turning it.
Why is my pilotair Air Compressor rotating in the wrong direction?
If the electric connection causes the compressor to turn in the opposite direction, switch off the power and invert two of the three phases.
How to troubleshoot low temperature in pilotair Air Compressor?
If the oil temperature is below the programmable fixed limit, check the heater connection, if present. If there is no heater, install one.
What to do if the inverter is blocked on my pilotair Air Compressor?
If the inverter has generated an alarm, read the fault indicated on the inverter display and follow the instructions in the inverter manual.
What does Temp Alarm 2 mean on my pilotair Air Compressor?
If the auxiliary temperature probe measures a value higher than the set threshold, the machine stops. Contact Power System.
Crucial safety warnings and procedures for operation and ordering.
Procedure for requesting spare parts and filters.
Explanation of the CE marking and its significance for conformity.
Procedures for ensuring the machine is safely powered off before maintenance.
Critical restrictions and forbidden applications for safe compressor operation.
Instructions and safety precautions for lifting and moving the compressor.
Crucial safety warnings for compressor installation and environment.
Guidelines for optimal and safe placement of the compressor.
Step-by-step guide to powering on and starting the compressor.
Table listing common faults, causes, and remedies for the EPS4.3 control panel.
Safety precautions and general rules for performing maintenance.
Step-by-step guide for replacing the oil and oil filter.
Procedure for checking and maintaining the correct oil level in the compressor.
Instructions for replacing the oil separating filter cartridge.
Steps for removing and replacing the air/oil separator cartridge.
Procedure for changing the air filter cartridge.
General| Brand | pilotair |
|---|---|
| Model | DCR 1311 |
| Category | Air Compressor |
| Language | English |
To Next Page
