PERFORMING SERIES
Displays the details of the series:
Number of the series
Total - the number of programmed units (100)
Completed - the number of already cut pieces (50)
Feed - feed type return / gradual
50 100
TotalFinished
SERIES NO.
6
FEED
Work screen in the NC mode clearly displays the status
of the performing series. Active buttons are only SERIES,
INTERRUPT and CORRECTION.
340 100 32
mm mm mm/min
340
mm
100
mm
32
mm/min
The adjusted height of the arm uplift
Current position of the arm
Speed of the arm descent
CORRECTION
1.12
mm
493.0
20.00
mm
493.0
20.00
CORRECTION
1.12
The adjusted length of the cut material
Current position of the movable vice
TIMES
Latest
pc
min sec
0 00
0 00
Remaining
ACTIVE SERIES
After pressing the button SERIES, a screen for viewing
and setting of the cut series will appear on the display.
During the execution of the series, it is possible to set up
the following series without interrupting the cycle. If the
editing of the next series takes too long and the machine
completes the previous series in the meantime, cutting of
the next series will not start until the editing is not
completed.
After pressing the INTERRUPT button, the currently
executed the cut will be completed and the next one
interrupted (for example, due correction), the switching
to the Series screen is aborted.
SERIES
INTERRUPT
Displays information about the work
time.
Display active series.
Informs about the motion direction of the arm
1 2 5 6 7
8 9 12 14 15
4.1.5. Series
1 2 5 6 7
8 9 12 14 15
SERIES IN PROGRESS
0 9 : 2 0 : 0 3 0 8 / 1 0 / 2 0 1 6
CORRECTION
65
15 90
BLADE SPEED
m/min
1.12
6,5
0% 150%
AMMETER
A
50 100
TotalFinished
SERIES NO.
6
FEED
340 100 32
mm
mm mm mm/min
493.0
20.00
SERIES
INTERRUPT
TIMES
Latest
pc
min sec
ACTIVE SERIES
0 00
0 00
Remaining
Displays the details of a moving vice motion:
Displays the details of the arm motion:
Correction can be set also during
the performance of the cut.
To Next Page
Loading...
Need help?
General