Pilz PSEN sc B 5.5 User Manual

Contents
Operating Manual PSEN sc B 5 Series
1004508-EN-02
4
6.3 Installation of the protective bracket PSEN sc bracket H at the safety laser
scanner
30
6.4 Installation with setting of angle of inclination/roll angle - bracket PSEN sc
bracket P
31
6.5 Installation with angle of inclination setting - holder PSEN sc bracket P 33
6.6 Set the angle of inclination of the safety laser scanner 34
6.7 Set the side inclination of the safety laser scanner 34
6.8 Measures to safeguard unsecured areas 35
Section 7 Wiring 37
7.1 General guidelines 37
7.2 Connector pin assignment 37
7.3 Wiring of the configurations 38
7.3.1 Wiring configuration example A 39
7.3.2 Wiring configuration example B 40
7.3.3 Wiring configuration example C 40
7.3.4 Wiring configuration example D 41
7.4 Connect supply voltage and safety controller 41
7.5 Connection to PSENscan Configurator 43
Section 8 PSENscan Configurator 44
8.1 Basics 44
8.2 Installation 44
8.2.1 System requirements 44
8.2.2 Install PSENscan Configurator 44
8.2.3 Ethernet Connections 45
8.2.3.1 Factory default settings for the IP addresses 45
8.2.3.2 Connect automatically 45
8.3 Download configuration to device 45
Section 9 First commissioning 47
9.1 Requirements for commissioning 47
9.2 System connection 47
9.3 Configuration of zones 48
9.3.1 Example configuration A 48
9.3.2 Example configuration B 49
9.3.3 Example configuration C 51
9.3.4 Example configuration D 53
9.4 Testing 55
Section 10 Operation 57
10.1 Diagnostic information 57
10.1.1 Error 57
10.1.2 Warnings 59
10.1.3 Information 59
10.2 Display during normal operation 60

Pilz PSEN sc B 5.5 Specifications

General

Brand	Pilz
Model	PSEN sc B 5.5
Category	Scanner
Language	English