09
3.2.8. New controller pairing (left and right controller need to be
paired separately)
Step 1:
Charge the controller for at least 15 minutes before pairing to ensure sufficient power of the controller.
Step 2:
Cancel pairing: Press the menu button + π button at the same time until the blue light is on.
Step 3:
Click SET PAIR in the Pimax Play, then press and hold A+B/X+Y until the controller’s indicator light begins flashing blue.
Step 4:
According to the prompt, and then click PAIR in the Pimax Play.
Step 5:
Wait for the controller’s green indicator light to come on. Once the light comes on the Pimax Play will that the controllers
have been paired and the UI should show the controller graphic illuminated in the color green.
When the indicator light Flashes Red, it is charging. If the indicator does not flash, re-plug the charging cable or press the π
button.
It is paired by default when leaving the factory.
The pairing of controllers needs to be done individually one by one
During the pairing process, it is necessary to ensure that the headset is not in sleep mode.
To Next Page
Loading...
