16
Disconnect the Controller
Press and hold the Home button until the status indicator turns red and the Controller vibrates.
Pairing a new Controller
If you need to pair a new Controller (the VR Headset can only connect one left Controller and one right Controller) or reconnect with an
unpaired Controller
Go to “Settings” ►“equipment”► “Controller”, click on “Pair”. Press and hold the“A button+B button”/“X button+Y button”of the controller
at the same time until you feel a slight vibration (lasting about 4s), if the status indicator of the controller changes from blue to green,
the pairing has been completed successfully.
Sleep / Wake up the Headset
Option 1 (Proximity Sensor):
Option 2 (POWER Button):
Take off the VR Headset will initiate the automatic sleep function: putting the Headset on will wake the
headset from sleep
Press the Power button of the Headset for manual sleeping or waking up.
Sleep / Wake up the Controller
Wake up
① Pick up or touch the controllers to wake them up automaticall
② Short press any button on the controllers to wake them
Sleep
① When the headset is working normally, the controllers will enter sleep mode after
being idle for 15 minute
② When one of the following conditions is met, the controllers will sleep immediately:
1. When the headset is hybernating
2. When the controllers are unpaired
3. When the headset is turned off.
Hardware
r
eset
VR Headset reset:
If the visual in the headset free
z
es, or the headset does not respond after a short press of the Power button, you can press the Power
button of the headset for more than 1
0
seconds to reboot the headset
Controller reset:
If the controllers have no response to the home button and/or any button or the virtual controllers in the headset is stuck, you can press
and hold the
π
button of the controllers for
9
seconds to reset the controllers
The VR Headset Ad
j
ustment:
This device has no myopia ad
j
ustment function. The headset allows wearing most standard glasses with a frame width of less than
1
50
mm.
C
AUTION
REA
D C
AREFULLY
When the headset wakes up after hibernation, it may experience a temporary position shift, which it will recover from after a
moment.
C
AUTION
REA
D C
AREFULLY
The virtual security
z
one reminder function of this product cannot completely guarantee your safety in the set area. Please pay
attention to the surrounding security situation at all times
Controllers
w
ill a
u
to
m
aticall
y
l
ow
p
ower
m
ode to
s
a
v
e
p
ower
i
n the
f
ollowing
c
ases
:
The controller has been idle for 1
5
minute
When the Headset enters deep sleep (a while after the VR Headset is taken off)
When the Controllers are unpaire
When the Headset is powered off
To Next Page
Loading...
