7
Getting started
Supersound 001 is easy to use. To play DAB or FM radio, all you need is a
power source (batteries or USB power).
Quick setup
Fully extend the Telescopic antenna to ensure good reception in both DAB and
FM Radio modes. It may be necessary to alter the position of the DAB Digital
Radio and/or the Telescopic antenna to achieve the best signal.
1. Insert four “AA” batteries (not included) into the battery compartment or
connect the USB cable to the input in the side of the Supersound 001 and
then plug the cable into the USB powers adapter.
2. Fully extend the rear telescoping antenna.
3. Press the VOLUME button to turn the Supersound 001 on.
4. Press the SOURCE button to select the desired source.
Turn ON / OFF or set to Standby
Power on: short press VOLUME
Power off/standby: long press VOLUME
Note: Unplug the USB power to turn off your Supersound 001 completely.
SOURCE: Press repeatedly to cycle through the sources: DAB, FM, Bluetooth.
Preset stations
There are 20 DAB presets and 20 FM presets.
To store a station, selected your desired radio station, then press and hold the
preset button (1, 2 oder 3+) for a seconds until the LCD display shows “Preset #
saved”.
In case of “3+” either press 9 or : button to select your desired station preset
number, press VOLUME to confirm your selection.
Recall stations
To recall a preset station, press button 1 or 2 once, or in case of 3+ either press
9 or : to select the preset number. Then press VOLUME to confirm.
Note: If you choose a preset that hasn’t been allocated a station, then “Preset
Empty” will be displayed.
To Next Page
Loading...