To Next PageTo Next PageWhy is the loading mechanism on my Pioneer Media Player operating improperly?
If soldering is improper, resolder it. If the wires are broken, replace them. If the signal waveform is not proper, loose connection and the loading detection SWs (S1701 and S1702) may be improperly soldered or defective. For any power-supply section that does not output the voltage, check the mounting statuses of the regulator IC and its peripheral parts.
Why are there no key functions on my Pioneer Media Player?
If there is no loose connection and if the signal does not become "L" when the SW is pressed, that SW is defective. If the symptom persists after the above corrections, check a mounting state of PANEL CPU (IC1007). If the mounting is OK, the IC1007 may be defective.
How to fix a Pioneer Media Player when the rotary selector is not controllable?
If the signals are not normal, check the connections of the signal lines. If the connections are properly made, the Rotary selector (S1018) may be defective and should be replaced. If the symptom persists after the above corrections, check a mounting state of PANEL CPU (IC1007). If the mounting is OK, the IC1007 may be defective.
How to troubleshoot a startup failure on a Pioneer Media Player?
If the V+12_EUP voltage is not output, the POWER SUPPLY Assy may be defective. If the V+12_EUP voltage is output, the DFLB Assy may be defective. If the connection up to the Power switch is properly made and if the PWR_SW signal is not set to "L" when the Power switch is pressed, the Power switch may be defective. If the PWR_ON is "L", PANEL CPU(IC1007) may be defective. If the PWR_XON is "H", poor connection or Q2021 may be defective. If the voltage is not output, POWER SUPPLY Assy may be defective.
What to do if my Pioneer Media Player has a mode shift error in Standby mode?
If the connection up to the Power switch is properly made and if the PWR_SW signal is not set to "H" when the Power switch is turned off, the Power switch may be defective. If the PWR_ON is "H", PANEL CPU(IC1007) may be defective. If the PWR_XON is "L", poor connection or Q2021 may be defective.
Why does the DATA FL not light on my Pioneer Media Player?
If no signal is output, the PANEL CPU (IC1007) may be defective. If output signal is no problem, DATA FL (V1001) may be defective. Also, if the presence of power is not confirmed, check the mounting statuses of the regulator IC and its peripheral parts for each power supply.
Why does the JOG FL not light on my Pioneer Media Player?
If no signal is output, the PANEL CPU (IC1007) may be defective. If output signal is no problem, JOG FL (V1801) may be defective. Also, if the presence of power is not confirmed, check the mounting statuses of the regulator IC and its peripheral parts for each power supply.
What causes communication failure between the microcomputer in my Pioneer Media Player?
If no signal is output, the possible causes are poor connection, failure in the PANEL CPU (IC1007) or MAIN CPU (IC103), and startup failure of the MAIN CPU caused by defective FLASH ROM (IC101) or SDRAM (IC102).
General| USB direct playback | Yes |
|---|---|
| Product color | Silver |
| Type | - |
| Nominal speeds | - RPM |
| Signal-to-Noise Ratio (SNR) | 115 dB |
| Line outputs (RCA) | 1 |
| AC input voltage | 220-240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 21 W |
Weight and Dimensions| Depth | 364.4 mm |
|---|---|
| Width | 305 mm |
| Height | 105 mm |
| Weight | 3310 g |
