Pioneer CLD-1590K - User Manual

CD CDV LD PLAYER
0,
th
neartiices
Instructions
CLD-15
OOK
arias
lacarlaraala
Met ioe AGEs CAG
Ll’
LASER DISC
@ This player does not apply to business use, and CD-
RGM/CD graphic discs cannot be played with this player.
The function of both units, CLD-1580K and CLD-V720
COMPACT
are
identical.
DIGITAL AUDIO
Thank you for buying this Pioneer product.
Please read through these operating instructions so you
will know how to operate your model properly. After you
have finished reading the instructions, put them away in a
safe place for future reference.
In some countries or regions, the shape of the power plug
and power outlet may sometimes differ from that shown in
the explanatory drawings. However, the method of
connecting and operating the unit is the same
WARNING: To PREVENT FIRE OR SHOCK HAZARD,
DO NOT EXPOSE THIS APPLIANCE TO RAIN OR
MOISTURE,
IMPORTANT NOTICE
[For U.S. and Canadian models]
The serial number for this equipment is located on the rear panel.
Please write this serial ber on your enclosed warranty card
and keep it in a secure area. This is for your security.
[For Canadian model]
CAUTION: To PREVENT ELECTRIC SHOCK DO NOT
USE THIS (POLARIZED) PLUG WITH AN EXTENSION
CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE
LADES CAN BE FULLY INSERTED TO PREVENT BLADE
EXPOSURE.
ATTENTION: pPouR PREVENIR LES CHOCS
ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE
AVEC UN PROLONGATEUR, UNE PRISE DE COURANT
OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES
LAMES PEUVENT ETRE INSEREES A FOND SANS EN
LAISSER AUCUNE PARTIE A DECOUVERT.
LINE VOLTAGE SELECTOR SWITCH
Only multi-voltage models are provided with this switch.
U.S., Canadian, European, U.K., and Australian models
are not provided with this switch.
The line voltage selector switch is located on the rear pane!
of this player. Before your player is shipped from the factory,
the switch is set to the power requirements of the player's
destination. Check that it is set properly before plugging
the power cord into the outlet. If the voltage is not properly
set or if you move to an area where the voltage requirements
differ, adjust the selector switch as follows:
Use a medium-sized (flat blade) screwdriver. Insert the tip
of the screwdriver into the groove of the selector switch
and turn it to set the player to the power voltage of your
area.
Set the selector so that
arrow points power
voltage of your area
(Figure shows arrow
pointing to 110 volts}
@ PIONEER’
The Art of Entertainment

Pioneer CLD-1590K Specifications

General

Remote Control	Yes
Laser Type	Semiconductor laser
Type	LaserDisc Player
Disc Compatibility	LaserDisc, CD
LaserDisc Size	8-inch and 12-inch
Audio Output	Analog (RCA)
Video Output	Composite, S-Video
Frequency Response	4 Hz to 20 kHz
Dynamic Range	90 dB
Total Harmonic Distortion	0.003%
Output Level	2.0 V
Karaoke	Yes (with key control and microphone inputs)
Wow and Flutter	Below measurable limits