Additional information 08
39
En
Setting the TV system
(Except Taiwanese model)
The default setting of this player is AUTO, and
unless you notice that the picture is distorted
when playing some discs, you should leave it
set to AUTO. If you experience picture distor-
tion with some discs, set the TV system to
match your country or region’s system. Doing
this, however, may restrict the kinds of disc
you can watch. The table below shows what
kinds of disc are compatible with each setting
(AUTO, PAL and NTSC).
1 If the player is on, press STANDBY/
ON to switch it to standby.
2 Using the front panel controls, hold
down then press STANDBY/ON to
switch the TV system.
The TV system changes as follows:
• AUTO NTSC
• NTSC PAL
• PAL AUTO
Note
• You have to switch the player into standby
(press STANDBY/ON) before each
change.
Resetting the player
Use this procedure to reset all the player’s
settings to the factory default.
1 Switch the player into standby.
2 Using the front panel buttons, hold
down the (stop) button and press
STANDBY/ON to switch the player back
on.
All the player’s settings are now reset.
DVD-Video regions
All DVD-Video discs carry a region mark on the
case somewhere that indicates which
region(s) of the world the disc is compatible
with. Your DVD player also has a region mark,
which you can find on the rear panel. Discs
from incompatible regions will not play in this
player. In this case the attention sentence
Incompatible disc region number Can't
play disc is displayed on screen. Discs
marked ALL will play in any player.
The diagram below shows the various DVD
regions of the world.
Selecting languages using the
language code list
Some of the language options (such as ‘DVD
Menu Lang.’ in the Initial Settings) allow you to
set your preferred language from any of the
136 languages listed in the language code list
on page 41.
1 Select ‘Other Language’.
2Use the / (cursor left/right)
buttons to select either a code letter or a
code number.
3Use the / (cursor up/down) buttons
to select a code letter or a code number.
See Language code list on page 41 for a
complete list of languages and codes.
Disc Player setting
Type Format NTSC PAL AUTO
DVD/Super
VCD/Video CD/
DivX Video
NTSC
NTSC PAL NTSC
PAL
NTSC PAL PAL
CD/MP3/WMA/
JPEG
no disc
—
NTSC PAL
NTSC
or PAL
1
2
2
5
5
6
3
2
1
4
4
DV300_IBD_EN.book 39 ページ ２００７年３月１４日 水曜日 午後９時４７分
To Next Page
Loading...
Need help?
General
