- 28 -
Regardless of whether the [AUTO APP CONN] setting is set to [ON] or [OFF], you can
also perform the following to start Pioneer Smart Sync.
• For devices other than the USB-connected Android device, press SRC/OFF to select
any source and press and hold the M.C. dial.
• For iPhone, launch Pioneer Smart Sync on the mobile device.
• When you connect a mobile device other than an iPhone/Android device, it may not operate
correctly depending on your mobile device.
• If Pioneer Smart Sync has not been installed on your iPhone/Android device yet, a message that
prompts you to install the application will appear on your iPhone/Android device (except for the
Android device connected via Bluetooth). Select [OFF] in [AUTO APP CONN] to clear the message
(page 37).
1 Press SRC/OFF to select [APP].
(Network mode is only available for FH-S720BS/S722BS/MVH-S620BS/S622BS.)
You can also make various adjustments in the AUDIO settings (page 32).
This unit features two operation modes: network mode and standard mode. You can
switch between modes as desired (page 9).
Network mode
You can create a 2-way + SW multi-amp and multi-speaker system with high range
speaker, middle range speaker and subwoofer for reproduction of high, middle and low
frequencies (bands).
Standard mode
You can create a 4-speaker system with front and rear speakers or front speakers and
subwoofers, or a 6-speaker system with front and rear speakers and subwoofers.
You can adjust the cut-off frequency value and the slope value of each speaker.
Listening to music on your device
Audio Adjustments
Operation modes
Adjusting the cut-off frequency value and the slope
value
To Next Page
Loading...
Need help?
General
