Need help?Do you have a question about the Pioneer GM-6300F and is the answer not in the manual?
General| Channels | 4 |
|---|---|
| Signal-to-Noise Ratio | 100 dB |
| Speaker Level Inputs | Yes |
| Preamp Outputs | Yes |
| Bridged Power (4 ohms) | 150W x 2 |
| Frequency Response | 10Hz - 50kHz |
| Bridged RMS Power at 4 Ohms | 150W x 2 |
| Bass Boost | 0-12dB |
When the unit does not operate properly, contact your dealer or the nearest authorized PIONEER Service Station.
Never replace the fuse with one of greater value or rating than the original fuse. Use of an improper fuse could result in overheating.
Always use the special red battery and ground wire [RD-223], which is sold separately. Connect the battery wire directly to the car battery positive terminal.
The power indicator lights when the power is switched on.
For two-channel input, slide this switch to the left. For four-channel input, slide this switch to the right.
Adjusting the gain controls A and B will help match the output of the car stereo to the Pioneer amplifier.
If you hear a beat while listening to an MW/LW broadcast, change the BFC switch using a small standard tip screwdriver.
Set the LPF/HPF select switch according to the type of speaker that is connected to the speaker output connector.
Disconnect the negative (-) terminal of the battery to avoid the risk of short-circuit and damage to the unit.
Speakers must conform to standards; impedance must be 2 Ω to 8 Ω (4 Ω to 8 Ω for bridged connections).
Diagram showing how to connect the car stereo, amplifier, and speakers using RCA and speaker input connectors.
Step-by-step guide on how to connect the power terminal, including routing wires and attaching lugs.
Instructions on connecting the car stereo speaker output wires to the amplifier using the supplied speaker input connector.
Guide on how to expose speaker wire ends, attach lugs, and connect them to the speaker output terminals.
Detailed instructions for connecting speakers and input wires for four-channel, three-channel, and two-channel modes.
Do not install in places where it could injure the driver or passengers if the vehicle stops suddenly.
Ensure proper heat dissipation by allowing adequate space above the amplifier for proper ventilation.
Step-by-step guide on how to place the amplifier and drill holes for mounting on the floor mat or chassis.
To Next Page
