Need help?Do you have a question about the Pioneer GM-6000F and is the answer not in the manual?
When the unit does not operate properly, contact your dealer or authorized Pioneer Service Station.
Warning against improper speaker wiring for bridged mode, which can cause damage and overheating.
Important safety precautions including battery connection, avoiding wet hands, and proper wiring.
Adjusting gain controls helps match car stereo output to the amplifier. Set to NORMAL position.
Slide switch for two-channel input to the left, four-channel input to the right.
Select cut off frequency from 40 to 120 Hz when LPF/HPF switch is set.
The power indicator lights when the power is switched on.
Change BFC switch with screwdriver if a beat is heard while listening to MW/LW broadcast.
Set LPF/HPF select switch according to speaker type and car stereo system.
Diagram showing how to connect the amplifier to the car's power and audio system.
Detailed steps for connecting the battery wire, ground wire, and system remote control wire.
Instructions for exposing speaker wire ends and attaching lugs for connection.
Guides connection of speakers and input wires for four-channel, three-channel, and two-channel modes.
Provides steps for mounting the amplifier using tapping screws and drilling holes.
To Next Page
General
