Need help?Do you have a question about the Pioneer GM-X354 and is the answer not in the manual?
General| Number of Channels | 4 |
|---|---|
| Signal to Noise Ratio | 100 dB |
| THD at RMS Power | 0.05% |
| Crossover | Variable |
| Low Pass Filter | 50 Hz - 200 Hz |
| High Pass Filter | 50 Hz - 200 Hz |
| Frequency Response | 10 Hz |
| Bass Boost | 0 |
| Input Sensitivity | 200mV - 4V |
Steps to take when the unit does not operate properly, contact dealer or service station.
Important safety instructions covering electrical shock, traffic safety, and installation.
How to match the car stereo output to the amplifier using gain controls.
Setting the switch for two-channel or four-channel input based on car stereo configuration.
Explanation of the Power Indicator, BFC, and LPF/HPF select switches.
Safety guidelines for wiring, preventing damage, and avoiding short-circuits.
Requirements for speaker impedance and guidelines for routing wires safely.
Diagram showing RCA and speaker input/output connections and power wiring.
Step-by-step instructions for passing and connecting battery and ground wires.
Procedure for preparing speaker wires and connecting them to output terminals.
Connecting car stereo speaker output wires to the amplifier's input connector.
Instructions for connecting speakers in four-channel, three-channel, and two-channel modes.
Safety advice on amplifier placement and securing to prevent injury or damage.
Steps for installing the amplifier using tapping screws and drilling holes.
To Next Page
