Pioneer RG-2 - User Manual

RG DYNAMIC PROCESSOR
1h pp 2oSBlLT Mm
MPIONEER'
G-2
OPERATING
INSTRUCTIONS
SPECIFICATIONS
Semiconductors
Ics 4
Transistors F)
Diodes 30
Processor Section
Maximum Output Vohiage ON
(Ik, T-H.D.:0.5% Ry :A7K2, DYNAMIC
EXPANSION: 16dB)
‘Total Harmonie Distortion 0.08%
(Qutput:1¥, kHz, DYNAMIC EXPANSION 1643)
Dynamic Expansion 4,7,10, 13,1648
Gain
tees a
DYNAMIC | yay
EXPANSION)
Upward Gain| +248
[ Dovoward
Impulse Response
Attack Time
Release Time
Input Impedance
4aB | +68 | +8dB
2B 348
i
T
+10dB
4dB | SB
648
03mse:
120msee
SKS? (20H7 to 20kHa)
Ss
S/G
Before turning on the power, please confirm the
setting of the line VOLTAGE SELECTOR switch
on the rear panel. If it is not set properly, change
the seiting of it according to the LINE VOLTAGE
SELECTOR SWITCH on page 3.
NOTE:
‘These operating instructions apply to two nersions of the
RG-2, The KG-2/8/G model 1s supplied with the rack
mount adaptors as an accessory, while RG-2/8 model ie
‘tot supplied with it How to anstall the rack mount odap-
tore is deserdbed on page 8
‘Output Impedance 3000 (1H)
Residual Noise roy
(HF A, DYNAMIC EXPANSION: 16d)
‘Signal to Noise Ratlo (IHF A, Shortcrcuited, DYNAMIC
EXPANSION: 1648)
1006 (at 1¥]
116dB (at 6.5¥)
Miscellaneous
Power Requirements. Hovp1zovi220v/240v
(switchable), 50/6042
. 108
1 g20(i)99{11336(D}mm
16:3) 6(W|x3-7/8(1i)x1 3+ /4(D)in
4g (9Ib 102)
Power Consumption
Dimensions
Weight (without package)
Furnished Parts
Connection cord with pin plugs 2
Operating instructions
Rack mount adaptors (5/6 model only),
Nore:
Specifications and the design subject to possible modifica
tion without notice due to improvements

Summary

Specifications

Processor Section

Specifications related to the audio processing capabilities.

Features

Broadens Dynamic Range

How the unit expands the music's dynamic range.

Design Oriented toward High S;N and Low Distortion

Highlights the unit's audio quality design.

5-Stage Dynamic Expansion Selector

Describes the user-selectable expansion levels.

Rear Panel Facilities

Line Voltage Selector Switch

Switch to set the correct voltage for operation.

Installation Precautions

Connections

Connections to Stereo Amplifier

How to connect the RG-2 to a stereo amplifier.

Tape Deck Connectivity

How to connect the RG-2 to a tape deck.

Front Panel Facilities

Dynamic Expansion Controls

Details on the meter and selector for dynamic expansion.

Processor Function Switch

Input Level Adjustment

Operation

Pre-Operation Checks

Recommended settings before powering on the unit.

Step-by-Step Operation

A guide to performing basic operations.

For Maximum Enjoyment

Music Source Effects

RG-2 Technical Outline

Block Diagram and Circuitry

Pioneer RG-2 Specifications

General

Type	Dynamic processor
Total Harmonic Distortion	0.05%
Input Sensitivity	150 mV
Input Impedance	50 kOhms
Output Impedance	600Ω