What to do if Pioneer S-21W Speaker System speakers stop producing sound suddenly?
If your Pioneer Speaker System suddenly stops producing sound, it's likely that the automatic protection circuit has been activated due to an excessively large signal input. To fix this, simply turn the volume down. This should allow the speakers to resume normal output.
Why is there no sound coming from my Pioneer Speaker System but the indicator is lit blue?
If your Pioneer Speaker System is not producing any sound, and the indicator light is blue, there are a few potential causes. First, ensure that the accessory RCA plug cord is correctly connected. If it's not, check the connections and correct them. Secondly, check the volume knob and make sure it's not set to MIN. If it is, slowly turn it clockwise to increase the volume. Finally, the input level might be too low. Try raising the receiver’s output level to see if that resolves the issue.
How to fix distorted sound on Pioneer Speaker System?
If your Pioneer Speaker System is producing distorted sound, it could be due to the level being too high. Try turning the volume knob counter-clockwise to lower the level. Alternatively, the input level might be too high. In this case, turn the receiver’s output level (volume, bass control, bass boost) counter-clockwise to lower the level.
What to do if my Pioneer S-21W has no sound and the power indicator lights red?
If your Pioneer Speaker System isn't producing any sound and the power indicator light is red, the unit has likely entered standby mode. To resolve this, simply turn the Auto Standby function OFF.
Why does my Pioneer Speaker System have no sound?
If your Pioneer Speaker System is not producing any sound, there are several possible reasons. First, check the speaker wire connections to ensure they are correctly connected. Second, make sure your receiver is turned on. Finally, verify that the volume control is not set to zero; if it is, slowly turn up the volume.
How to stop howling noise on Pioneer Speaker System?
If you are experiencing howling noise with your Pioneer Speaker System, it could be due to a couple of reasons. One possibility is that the receiver is not properly powered. Ensure that a receiver is connected and supplied with power. Another reason could be that the subwoofer level is set too high. Try placing the subwoofer a good distance from the speakers and turn the volume knob counter-clockwise to lower the volume.
Why is my Pioneer S-21W not turning on?
If your Pioneer Speaker System is not receiving power (the indicator does not light up when the POWER switch is turned on), the power supply plug may not be correctly inserted. Ensure that the plug is securely inserted.
Why is there so much noise when listening to AM/FM broadcasts on my Pioneer Speaker System?
If you are experiencing a lot of noise when listening to AM or FM broadcasts on your Pioneer Speaker System, the AM loop antenna or the FM indoor antenna might be too close to the unit. Try increasing the distance between the AM or FM antenna (for indoor use) and the speaker system.
General| Impedance | 47000 Ω |
|---|---|
| Subwoofer type | Active subwoofer |
| Subwoofer peak power | 160 W |
| Subwoofer driver diameter | 160 mm |
| Subwoofer frequency range | 33 - 700 Hz |
| AC input voltage | 220 - 240 V |
| AC input frequency | 50 - 60 Hz |
| Power consumption (typical) | 25 W |
| Product color | Black |
Weight and Dimensions| Subwoofer depth | 344 mm |
|---|---|
| Subwoofer width | 230 mm |
| Subwoofer height | 408 mm |
| Subwoofer weight | 6500 g |
To Next Page
