CN7016
CN7602
CN7502
CN8711
CN7015
CN7014
CN7013
CN3802
CN3801
CN6811
JP5001
CN6821
CN7708
CN7704
CN5003
CN5002
CN7709
JP6007
21P FFC
(GGD1590)
Diagnosis
17P + 19P board to board extension jig cable
(GGD1593)
24P + 15P board to board extension jig cable
(GGD1651)
5P PH Housing Assy
(GGD1594)
9
7
1 4
6 3 2 19P FFC
(GGD1589)
5P PH Housing Assy
(GGD1594)
11P FFC
(GGD1650)
5
11P FFC
(GGD1650)
8
8P PH Housing Assy
(GGD1652)
27P FFC
(GGD1588)
No. Jig Cable Part No. Assy Assy Remarks
1 27P FFC GGD1588 INTERFACE CN7015 <-> CN7709 FRONT BRIDGE Audio
2 19P FFC GGD1589 INTERFACE CN7013 <-> CN5002 AUDIO Audio
3 21P FFC GGD1590 INTERFACE CN7014 <-> CN5003 AUDIO Audio
4 11P FFC GGD1650 INTERFACE CN7016 <-> CN7708 FRONT BRIDGE Front I/O check
5 11P FFC GGD1650 COMPONENT CN6006 <-> CN7704 FRONT BRIDGE Power supply
6 17P + 19P board to board extension jig cable
GGD1593 ICE INTERFACE CN3801 <-> CN6821 ICE_BUFFER Audio (Speaker output)
GGD1593 ICE INTERFACE CN3802 <-> CN6811 ICE_BUFFER Audio (Speaker output)
7 24P + 15P board to board extension jig cable
GGD1651 COMPONENT CN6009 <-> CN1253 DIGITAL MAIN Video
GGD1651 COMPONENT CN6004 <-> CN1251 DIGITAL MAIN Video
8 8P PH Housing Assy GGD1652 COMPONENT JP6007 <-> CN7602 REG FL power supply
9 5P PH Housing Assy GGD1594 AUDIO JP5001 <-> CN7502 REG Audio
a 5P PH Housing Assy GGD1594 PRIMARY CN8711 <-> JP7701 FRONT BRIDGE Power supply
CN1251
CN6004 CN6009
CN6006
JP7701
CN1253
10
(1) Reassembling the AUDIO Assy etc..
(2) Reassembling the PRIMARY Assy.
(3) Tighten the screws of the ground points, and
temporarily assemble the rear panel.
(4) Connect the 10 extension jig cables.
(5) Connect the ground points to the chassis
ground. (See “Ground points”.)
(6) Arrange the unit as shown in the photo below.
Note: When diagnosing, it is not necessary to connect FAN cable (FRONT BRIDGE: CN7701).
To Next Page
Loading...
