[Procedures]
1. Either directly connect the PC and AV amplifier (Connection A) or connect them via a DHCP router (Connection B).
(1) Set the remote control operation switch to SOURCE (SC-LX82 only).
(2) Press the HOME MEDIA GALLERY button to set the input function to Home Media Gallery.
The Top menu will be displayed on the OSD.
(3) Select “Setup” then press ENTER.
(4) Select “Network Setup” then press ENTER.
(5) When “Network Found” or “No Network” is displayed, press ENTER.
(6) Select “Static IP Address” then press ENTER.
(7) Select “Change” then press ENTER. Enter the following values:
(8) After setting “Proxy Server,” press ENTER. The screen will be returned to the Top menu.
IP Address: 192. 168. 000. 002
Subnet Mask: 255. 255. 255. 0
Gateway IP: 192. 168. 000. 001
Proxy Server: [No]
*
Note:
Be sure to note the network settings (IP address, subnet mask, gateway, proxy server)
of the customer’s unit when the static IP address has been set for the unit.
2. [When the PC and AV amplifier are directly connected]
Set the static IP address of the AV amplifier.
How to Set the IP Address
In the Local Area Connections
Properties window, click on OK to
close the window.
Setting of the static IP address for the PC is completed.
To Next Page
Loading...
