To Next PageTo Next Page
Need help?Do you have a question about the Pioneer SX-1500T and is the answer not in the manual?
Power| power supply voltage | 110V, 117V, 130V, 220V, and 240V |
|---|---|
| power consumption | 220 watts |
| rms rated power output | 4060 watts per channel |
Weight and Dimensions| weight | 25 lbs / 11.3 kg |
|---|---|
| weight net | 30 lbs / 14 kg |
| dimensions (width x height x depth) | 16 7/16" / 418 mm x 5 1/2" / 140 mm x 13 3/4" / 347 mm |
Highlights the use of FET in the FM front-end for enhanced reception.
Details the use of IC in the FM tuner for improved capture ratio and reliability.
Details the electronic switching for protecting power transistors.
Provides guidance on suitable locations to install the receiver for optimal performance and safety.
Instructions on how to adjust the line voltage selector and check the fuse.
Explains the speaker system selection and power off function.
Details the tuning control and the meter used for accurate station tuning.
Details the selector switch positions for various input sources and broadcast types.
How to adjust bass, treble, balance, and volume levels.
Explains the function of low filter, high filter, and muting switches.
Describes the AFC switch for tuning stability and phono input selection.
Selects stereo/mono modes and tape monitoring functions.
Terminals for connecting AM and FM antennas.
Input jacks for turntables, auxiliary devices, and tape monitors.
Output jacks for connecting to a tape recorder's inputs.
Terminals for connecting main and extra loudspeakers.
Selector for choosing the appropriate line voltage for operation.
Guidance on positioning and connecting the AM ferrite loopstick antenna.
Instructions for connecting and positioning indoor/outdoor FM antennas.
Procedure for connecting one or two pairs of loudspeakers.
Step-by-step guide for tuning and listening to FM stations.
Guide for tuning and listening to AM broadcast stations.
Instructions for playing records using the phono inputs.
Steps for recording audio signals onto a tape recorder.
Steps for playing back recorded tapes through the receiver.
How to monitor recordings in progress with a tape recorder.
Diagnosing and correcting noise during AM/FM reception.
Diagnosing and correcting noise or howling during record playback.
Troubleshooting power-on problems and record howling.
Detailed procedure for aligning the AM tuner section.
Detailed procedure for aligning the MPX (Multiplex) section.
Step-by-step guide for aligning the FM tuner section.
Lists the types and quantities of transistors, diodes, and ICs used.
Details performance specifications for tuner, AM, FM, and multiplex sections.
Covers audio output, input impedance, sensitivity, and tone controls.
Information on power requirements, dimensions, and weight.
