EasyManuals Logo

Pioneer X-EM12 User Manual

Pioneer X-EM12
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #15 background imageLoading...
Page #15 background image
Bluetooth
® Audio playback (X-EM22 only)
15
En
English
Français Español
06
3 Confirm on the Bluetooth capable device
that pairing has been completed.
If pairing with the Bluetooth capable device has been
completed correctly, a beep will sound, and the
Bluetooth indicator will switch from blinking to staying
lit.
•If the Bluetooth indicator will not switch from blinking to
staying lit, the pairing was not completed correctly so
please try pairing with the unit again.
If paring has been completed correctly, you need not
repeat this procedure again.
Even devices that have already been paired with this unit will
not connect during pairing mode in the following cases.
In such cases, delete pairing history from the Bluetooth
wireless technology device and perform pairing again.
In order to pair with the unit, press and hold the  on the
unit for 3 seconds.
Up to 8 pairing history can be recorded with this unit. If
connecting to a Bluetooth wireless technology device
over 8 units, the oldest pairing history will be deleted.
If the settings are reset to the factory setting, all pairing
history will be deleted. In order to reset to factory setting,
press and hold the  on the unit for more than 8
seconds.
Listen to music on the unit from a
Bluetooth
capable device
1 Press
BLUETOOTH
on the remote control or
INPUT
repeatedly on the main unit to switch the
source to [
BT
].
The unit will start using the BT function, and connect with a
Bluetooth capable device.
2A Bluetooth connection will be created
between the Bluetooth capable device and the
unit.
Procedures for connecting to the unit should be performed
from the Bluetooth capable device.
Please refer to the user’s manual for your Bluetooth
capable device for details of the connection procedures.
3 Playback music from the Bluetooth capable
device.
Note
When Bluetooth capable devise is not connected and no
operations have been performed for more than 15
minutes, the unit will automatically power off.
Radio wave caution
This unit uses a 2.4 GHz radio wave frequency, which is a
band used by other wireless systems (see list below). To
prevent noise or interrupted communication, do not use this
unit nearby such devices, or make sure these devices are
switched off during use.
Cordless phones
Cordless facsimiles
Microwave ovens
Wireless LAN devices (IEEE802.11b/g)
Wireless AV equipment
Wireless controllers for game systems
Microwave-based health aids
•Some baby monitors
Other, less common, equipment that may operate on the
same frequency:
Anti-theft systems
Amateur radio stations (HAM)
Warehouse logistic management systems
Discrimination systems for train or emergency vehicles
Note
In the event noise appears in your television image, there
is the possibility that a Bluetooth wireless technology
enabled device or this unit (including products
supported by this unit) are causing signal interference
with the antenna input connector of your television,
video, satellite tuner, etc. In this event, increase the
distance between the antenna input connector and the
Bluetooth wireless technology enabled device or this
unit (including products supported by this unit).
If there is something obstructing the path between this
unit (including devices supported by this unit) and the
device equipped with Bluetooth wireless technology
(such as a metal door, concrete wall, or insulation
containing tinfoil), you may need to change the location
of your system to prevent signal noise and interruptions.
Scope of operation
Use of this unit is limited to home use. (Transmission
distances may be reduced depending on communication
environment).
In the following locations, poor condition or inability to receive
radio waves may cause the audio to be interrupted or stopped:
In reinforced concrete buildings or steel framed or iron-
framed buildings.
Near large metallic furniture.
In a crowd of people or near a building or obstacle.
In a location exposed to the magnetic field, static
electricity or radio wave interference from radio
communication equipment using the same frequency
band (2.4 GHz) as this unit, such as a 2.4 GHz wireless
LAN device (IEEE802.11b/g) or microwave oven.
X-EM22_SYXE8_En.book 15 ペー 146月日 曜日 午後時4

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pioneer X-EM12 and is the answer not in the manual?

Pioneer X-EM12 Specifications

General IconGeneral
TypeHome audio micro system
Cassette deckNo
Product colorBlack
Optical disc playerYes
Impedance6 Ω
Bass reflex-
Speaker type2-way
RMS rated power30 W
Number of speakers2
Supported radio bandsFM
Preset stations quantity30
Display typeLED
Audio (L/R) in1
Apple docking compatibilityNot supported
Disc types supportedCD-R, CD-RW
Audio formats supportedMP3, WMA
Equalizer modesClassic, Flat, Jazz, Pop, Rock
Equalizer bands quantity5
Power sourceAC
Input voltage220-240 V
Input frequency50 - 60 Hz
Power consumption (standby)0.5 W
Power consumption (typical)15 W
Weight and Dimensions IconWeight and Dimensions
Depth247 mm
Width180 mm
Height121 mm
Weight1480 g

Related product manuals