Piper PA-28-151 User Manual

CIIEROKEE
WARRIOR
CLEANING
CLEANING
ENGINE
COMPARTMENT
Before
cleaning the
engine
compartment,
place
a strip of
tape over the magneto
vents
to
prevent
any
solvent from entering these units.
a.
Place
a
large
pan
under
the engine to
catch waste.
b.
With the engine
cowling
removed,
spray
or brush
the engine
with solvent or a
mixture of solvent and degreaser.
In
order to
remove especially
heavy dirt and
grease
deposits, it may be necessary to brush areas
that
were
sprayed.
CAUTION
Do not spray
solvent
into the alternator,
vacuum
pump,
statter,
or air
intakes.
c.
Allow the solvent to remain on the engine
from five to
ten minutes.
Then rinse
the engine clean
with additional solvent and allow
it to dry.
CAUTION
Do not operate the
engine until excess solvent has evaporated
or
otherwise been
removed.
d.
Remove the
protective
tape from the magnetos.
e. Lubricate
the
controls,
bearing surfaces, etc.,
in accordance
with the Lubrication
Chart.
CLEANING LANDING
GEAR
Before
cleaning
the landing
gear,
place
a cover
of
plastic
or a similar
waterproof
material
over the wheel and brake assembly.
a.
Place a
pan
under the
gear
to catch
waste.
b. Spray
or brush the
gear
area
with
solvent or
a mixture
of solvent and
degreaser.
In
order
to remove especially heavy dirt and
grease
deposits,
it may be
necessary
to
brush areas that were sprayed.
c.
Allow the solvent to
remain
on
the
gear
from
five to ten
minutes.
Then rinse the
gear
with additional solvent and allow
it to dry.
d.
Remove the cover
from
the
wheel and remove the
catch
pan.
e. Lubricate the
gear
in accordance with the Lubrication
Chart.
HANDLING
AND
SERVICING
ISSUED:
JULY
17,1973 l0'3

Piper PA-28-151 Specifications

General

Manufacturer	Piper Aircraft
Engine	Lycoming O-320-E3D
Horsepower	150 hp
Wingspan	30 ft 0 in (9.14 m)
Seating Capacity	4
Model	PA-28-151
Height	7 ft 3 in
Cruise Speed	108 knots (124 mph, 200 km/h)
Fuel Capacity	50 US gallons (189 liters)
Maximum Takeoff Weight	2, 325 lb (1, 055 kg)