Powerplant, fuel, oil
Engine manufacturer: ROTAX
Engine type: ROTAX 912 UL (80 HP)
Data below is data relevant for pilot. Consult the original Rotax engine manual for all other details.
The engine
TEMPERATURE °C / ROTAX ENGINE 912 UL 80 HP
cylinder head temp. (CHT); minimum, working, highest 80; 110; 120
max. CHT dierence /
exhaust gas temperature (EGT); normal, max. 650-885; 900
max. EGT dierence 30
cooling uids temperature (WATER); minimum, highest 50; 120
oil temperature (OIL TEMP); minimum, normal, highest 50; 90-110; 140
RPM, PRESSURE 912 UL 80 HP
oil pressure (OIL PRESS); lowest, highest bar (psi)
1.0; 6.0
(14.5; 87.0)
engine revolutions (RPM); on ground recommended 5500
RPM on ground; max. allowable 5800
magneto check at (RPM) 4000
max. single magneto drop (RPM) 300
Fuel and oil
ROTAX ENGINE 912 UL 80 HP
recommended fuel
unleaded super,
grade 87 and
up, no alcohol
content
also approved fuels
leaded* or
AVGAS 100LL*
recommended oil
API SJ SAE
10W-50
oil capacity typical 3 quarts (3 liters) check dipstick
*Engine life is reduced. Should you be forced to used this kind of fuel, change of engine oil every
50 ight hours is crucial. Please consult the manufacturer on which type of oil to use.
IMPORTANT!
Four-stroke engines should only be powered by unleaded fuel, for lead sedimentation inside the en-
gine shortens its life. Provided you are unable to use unleaded fuel, make sure engine oil and the oil
lter are replaced every 50 ight hours.
WARNING! Use of fuel with alcohol content and/or other additives is not permitted.
1-4
General