Page: 28
Use the wall plate as a guide and mark the
position of the xing holes with a pencil.
The height to install the wall plate should be
measured from the top of the desired desk
height to the top of the recessed area of the wall
plate.as previously explained.
1
49cm
Using a hole saw, cut 3 holes of 25mm diameter
centred on the top row of your wall plate pencil
markings for the Geex.
Drill 3 holes of 8mm diameter for the wall plugs.
2
WALL
*Not included
25mm hole saw or a 25mm Spade bit
Recommended tools
Installing on Plasterboard/Drywall.
To Next Page
