Step 1)
Remove the heater from its packaging and remove any packaging
materials from the heater and accessories. It is particularly
important to remove the foam strips that protect the bars during
transport. Carefully pull these strips away from the heater in the
direction of the arrow. If you have tested the heater function before
installing it, allow it to cool before installing it.
Step 2)
Next, carefully choose where you want to install the heater.
The heater can be installed under the following circumstances:
o On the wall using the wall/ceiling bracket
o On the ceiling using the wall/ceiling bracket
o To the eaves of the house using wall/ceiling bracket
Step 3)
Depending on the installation method chosen (wall, ceiling, brick,
etc.), select the right installation bracket.
Using the Allen key, undo the long screw on the bracket at the back
of the heater and insert the chosen installation bracket. Then tighten
the long screw using the Allen key so that the installation bracket is
secured correctly. You can also use this screw later to adjust the
angle of the heater once it has been installed on the wall or ceiling.
To Next Page
Loading...