Page 4 @&(%$*4.8"4,7%A'*#$"&8#B%/7*,#*%4,77%CDEEEDEFFD<=G=1 Item 57047
HI@6JK LM6NIJ;LO PI;OJ6OIOQ6H6JRM
L/*(,$"83%;8#$('4$"&8#
%N*,9%$.*%6OJ;N6%;PMLNJIOJ%HI@6JK%;O@LNPIJ;LO%#*4$"&8%,$%$.*%+*3"88"83%&2%$."#%
5,8',7%"847'9"83%,77%$*]$%'89*(%#'+.*,9"83#%$.*(*"8%+*2&(*%#*$%'/%&(%'#*%&2%$."#%/(&9'4$1
J&&7%H*$%R/
I$$,4."83%$.*%\,897*
QIRJ;LO[%J.*%\,897*%#&4Y*$%5,Z%+*%.*79%
9&)8%+Z%,%47"/%'89*(%$*8#"&81%%S*,(%IOH;D
,//(&^*9%#,2*$Z%3&337*#%+*2&(*%2(**"83%
\,897*%#&4Y*$1%%N*5&^*%47"/%4,(*2'77Z1
1. Align the hole on the Lower Handle with
the Handle Lock Button and connect
the Upper and Lower Handles together.
Make sure the Button clicks into place.
2. Loosen the Set Screw and insert the
assembled Handle into the Handle Socket.
3. Tighten the Set Screw.
U7**9"83
1. Turn handle counterclockwise
to open Release Valve.
2. Remove four screws holding on pump cover.
3. Remove Oil Fill Plug and top off hydraulic oil.
4. Apply pressure to saddle and quickly
pump handle several times.
5. Check Oil Fill Hole again and top off
with hydraulic oil if necessary.
6. Replace the Oil Fill Plug and turn handle
clockwise to close Release Valve.
7. Test several times for proper operation
before attempting to lift a load.
I99"83%L"7
1. Remove the Fill Screw.
2. Add high grade hydraulic fluid into the Fill Screw
slowly until the oil reaches the top of the oil fill hole.
O&$*-%Do not touch the Handle when
adding the hydraulic oil.
3. Replace the Fill Screw.
To Next Page
Loading...
