EasyManua.ls Logo

Pittway System Sensor PDRP-1001 - The PDRP-1001;PDRP-1001 A; Circuits

Default Icon
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
PDRP-1001/PDRP-1001A Document 50734 Rev B 12/21/97
5
1.0 The PDRP-1001/PDRP-1001A
1.1 Features
Microprocessor-controlled
Alarm and trouble resound
Four Style B/D Initiating Device Circuits
Two Style Y/Z Notification Appliance Circuits
Two Style Y Release Circuits
General alarm and trouble relays
Optional module for 4 zone/function relays (4XZM)
Optional transmitter module (4XTM). Complies with
NFPA 72 Auxiliary and Remote Station Fire Alarm
Systems.
Optional volt/amp meter module (4XMM)
Optional supervised remote annunciator
(RZA-4X). Requires LED Interface Module (4XLM)
Optional digital communicator (NOTI•FIRE 911AC).*
Complies with NFPA 72 Central Station and NFPA 72
Remote Station Fire Alarm Systems.
Designed for sprinkler standards NFPA 13, 15, and 16.
Disable/enable controls per initiating zone.
Last Event Recall
Battery/Earth fault supervision
Fuse protection on all Notification/Release Circuits
RMS regulated output power, 2.25 amps
7 amp/hour to 15 amp/hour battery options,
up to 90 hours standby
Resettable and non-resettable regulated
power outputs
Extensive transient protection
Watchdog timer to supervise microproces-
sor (includes MICRO FAIL LED)
Output circuits protected against false
activations.
Slide-in zone identification labels
Steel cabinet 14.5" wide by 16" high by 5"
deep
Dead-front dress panel option (DP-4X)
Trim ring for flush mount between 16" center
studs (TR-4XR)
Cross-zone (double-interlock) option
Municipal Box output.
Interface Module (4XLM)
Dual hazard operation
Adjustable discharge timer
* Applications which require the NOTI-FIRE 911AC is not FM approved.
1.2 Circuits
Input Circuits
Manual Release/Detector Circuit 1 (Style B/D)
Detector Circuit 2 (Style B/D)
Waterflow (Style B/D)
Supervisory (Style B/D)
Output circuits (optional auxiliary relay module (4XZM) tracks these four circuits)
Alarm/Waterflow Bell (Style Y/Z)
Waterflow/Supervisory Bell (Style Y/Z)
Releasing Circuit 1 (Style Y)
Supervisory Bell/Release Circuit 2 (Style Y)
Front Panel Control Switches
Switch 1 Tone Silence
Switch 2 Alarm Silence
Switch 3 Alarm Activate
Switch 4 System Reset