pivotcycles.com info@pivotcycles.com 1.877.857.4868
2
VAULT ISO FLEX REMOVAL
1.) Slide the Seat Post Clamp Cap off of the seat
post clamp and up the seat post to give you
space to loosen the Seat Post Clamp Screw.
2.) Loosen the Seat Post Clamp Screw with a
4mm hex wrench and remove the seat post.
3.) Slide the Seat Post Clamp up off the ISO
FLEX insert to access the Top Cap Bolts.
4.) Loosen and remove the Top Cap Bolts and
the Top Plate.
5.) Re-install the seat post and the seat post
clamp. Tighten the seat post clamp bolt on the
ISO FLEX insert. Clamping the seat post in a bike stand
can make the process easier.
6.) Pull down on the frame to remove the ISO
FLEX insert from the frame. This is a tight fit and
may require some rocking the frame back and forth to
release it from the frame.
To Next Page
Loading...
