Pkm WT8+5BE - 9.2 Error Codes Explained

~ 140 ~
MALFUNCTION
POSSIBLE CAUSE(S)
MEASURE(S)
THE DRYING PERIOD ENDS SHORTLY AFTER THE START OF THE
PROGRAMME.
1. Not enough clothes in the appliance.
Clothes are too dry for the selected
programme.
1. Select a drying programme suitable
for the laundry to be dried.
If the appliance has a malfunction not listed in the table above, or if you have
checked all items in the above table but the problem still exists, please contact the
aftersales service.
9.2 Error codes
ERROR CODE
POSSIBLE CAUSE(S)
MEASURE(S)
E 02
Problems with
the water
inlet.
1. Water tap closed.
1. Open the water tap.
2. Water pressure too low.
2. Wait some time.
3. Water inlet hose is frozen.
3. Defrost the water inlet hose.
4. Filter is blocked.
4. Remove the filters and clean
them.
E 03
Problems with
the water
outlet.
1. The « START / PAUSE » -
BUTTON is pressed and the
programme is paused.
1. Press « START / PAUSE » -
BUTTON again to restart the
set programme.
2. Water drain hose was
installed too high.
2. Max. height 100 cm.
3. Water drain hose is frozen.
3. Defrost the water drain hose.
4. Water drain hose is
blocked.
4. Remove the blockage and
clean the hose.
5. Water discharge is blocked.
5. Remove the blockage and
clean the water discharge.
6. Drain pump filter is
blocked.
6. Remove the drain pump
filter and clean it.
EXX
1. Other defects.
1. Switch off and unplug the
appliance, close the water tap
and contact the aftersales
service immediately.