AERMACCHI MB-339
26
PRINTING & CONSTRUCTION MANUAL
© PLANEPRINT
EN
Install the hinges (using the flaps as an example)
These spacers ensure
the correct gap distance.
Don´t remove!
Put the hinge in the
movable flap and
add a drop of liquid
CA glue to the gap.
Wait for the adhesive
to clot, then spray
the activator on it.
Then put the flap in the wing and put a
drop of CA glue on the hinge. Wait again
until the glue has run into it, then spray the
activator on it.
Be careful not
to use too much
glue, the flap
must move easily!
To Next Page