PLANEPRINT Aermacchi MB-339

Need help?

Do you have a question about the PLANEPRINT Aermacchi MB-339 and is the answer not in the manual?

Summary

PRINTING THE PARTS - PRINTING PROFILES

Important for the 1-wall-print!

Key settings for achieving optimal 1-wall print quality for airfoils.

PROFILE P1_FULLBODY

Printing specifications and part list for the full-body profile.

PROFILE P2_HOLLOWBODY

Printing specifications and part list for the hollow-body profile.

PROFILE P3_SURFACE

Printing specifications and part list for the surface profile, emphasizing 1-wall print.

PROFILE P4_FLEX

Printing specifications and part list for the flexible material profile.

REQUIRED ACCESSORIES

MATERIALS

List of physical materials and hardware needed for the model construction.

RC COMPONENTS

Essential electronic and mechanical RC components required for the aircraft.

TOOLS

Recommended tools for assembly and construction of the model.

Wing attachment

Installation EDF

Installation of the flap servos

Installation of the rudder and elevator servos

Assembling bowden elevator

Magnetic clasp Canopy

Retractable landing gear

Assembling nose landing gear

QUICK START GUIDE

TRANSMITTER CONFIGURATION

Settings and steps for configuring the radio transmitter for the model.

SETTING THE SERVO TRAVEL

Guide for adjusting servo travel limits for optimal control surface movement.

CENTER OF GRAVITY (CG)

Location and method for achieving the correct center of gravity for flight.

CONTROL DIRECTION TEST

CONTROL SURFACE TESTS

Verifies correct movement and direction for all control surfaces including ailerons, elevator, rudder, and flaps.

AGE RECOMMENDATION 14+