PLANEPRINT Aermacchi MB-339 - PROFILE P3_SURFACE

AERMACCHI MB-339
9
PRINTING & CONSTRUCTION MANUAL
© PLANEPRINT
EN
INFO
STL fi le: Canopy-1_p3.stl
Material: PLA
Weight: ~ 19 g
ADDITIONAL SETTINGS
Depending on your printer,
a brim may not be required.
 3_
The following parts must be sliced with the profi le
PROFILE P3_SURFACE (1 Wall Print).
Recommended additional settings are listed in the screenshots.
INFO
STL fi le: Aileron-left_p3.stl
Aileron-right_p3.stl
Material: PLA
Weight: ~ 10 g
ADDITIONAL SETTINGS
Depending on your printer,
a brim may not be required.
PLEASE NOTE
In profi le P3_SURFACE, there
should not be more than one STL
on the buildplate at the same time,
otherwise slicing errors can occur!