Specifications
•
Plul1~t
l
....
ucJio®
PA300 DIGITAL BASS PROCESSOR
Powerful
low
frequency enhancement system
for
bass afficianados
Input voltage level
Output voltage level
Frequency response
THO
Signal~to~noise
ratio
Balanced input noise rejection
Input impedance
Output impedance
Power
supply type
Fuse rating
15V
rms
10V
peak
(maximum)
10Hz
~
100kHz (+/-2dB)
0.003%
130dB
>60dB
10k
ohms
150
ohms
PWM
3A
All
specifications subject
to
change without notice.
Troubleshooting
If you experience operation or performance problems with this product, compare your
installation with the electrical wiring diagram on the previous pages. If problems persist,
read the following troubleshooting tips which may help eliminate the problems.
SYMPTOM POSSIBLE REMEDY
r------
Unit will not
Check that Battery
(+)
and
Ground connections are
not
reversed.T
power
up.
ICheck that all
wires
are properly connected
and
that adequate voltage
i (11-16V) is present.
Check that fuse
is
not
blown.
r---
Check that input level and output level are set correctly. Input level should
Sound is very
match the
output
of
the source unit,
and
output
level should match the
sensitivity
of
the audio unit connected
to
the Bass Generator's outputs.
distorted.
Check that input level
and
output level are set
correct/yo
Input level should
Volume level is
match the
output
of
the source unit,
and
output
level should match the
sensitivity
of
the audio unit connected to the Bass Generator's outputs.
very low.
Verify that the ground connection
is
secure, near the unit,
and
uses a
Engine noise
heavy gauge wire.
(alternator
whine)
Check that the Battery
(+)
wire
is
not
unnecessarily long.
Try connecting to
power
from a different
point
in the vehicle.
PA300 User's Manual - page 8
To Previous Page
Loading...
Need help?
General