Need help?Do you have a question about the Planet Audio VX602 and is the answer not in the manual?
General| Channel Configuration | 2-Channel |
|---|---|
| Frequency Response | 20 Hz - 20 kHz |
| THD @ RMS Power | 0.01% |
| Bass Boost | 0-12dB |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| RCA Inputs | Yes |
| Speaker Level Inputs | Yes |
| Low Pass Filter | 50 Hz - 250 Hz |
| High Pass Filter | 50 Hz - 250 Hz |
| RMS Power @ 4 Ohms | 75W x 2 |
| Signal to Noise Ratio | 90 dB |
| Input Sensitivity | 200mV - 6V |
Details on quasi-regulated power supplies, optically isolated muting, and high-speed diodes for rectifiers.
Information on MOSFET switches, Linkwitz Riley crossovers, and Class A mode driver stages.
RMS power, MAX power, bridge mono power, and minimum speaker impedance for various models.
THD, IMD, Frequency Response, Power Response, Input Sensitivity, and Signal-to Noise Ratio.
Phase adjustment, size, crossover settings, bass boost, and fuse ratings.
Instructions for locating, mounting, and connecting power and ground terminals for the amplifier.
Guidance on connecting the remote terminal and RCA cables for audio input.
Steps for inserting fuses, rechecking connections, setting controls, and fine-tuning.
Diagrams illustrating low-level input connections for various amplifier models.
Illustrations for connecting speakers and inputs using high-level signals.
Wiring configurations for two-channel, tri-mode, and bridged modes.
Wiring options for four-channel amplifiers in different operational modes.
Wiring diagrams for five-channel amplifiers, including tri-mode and bridged configurations.
Diagnosing issues like no power, protection LED activation, and no audio output.
Addressing problems such as hiss, squeal, distorted sound, and low output levels.
Troubleshooting overheating amplifiers and engine noise (static or alternator whine).
To Next Page
