INTRODUCTION
BATTER Y REP LAC EMEN T
C S 3
18
This marker uses 2 x AA Alkaline batteries for power. Accessing and
replacing them is a breeze.
FIG.1
Access the battery holder by firmly pulling the rubber foregrip sleeve
downwards A .
FIG.2
To access the batteries you must push in (or squeeze) the locking
tabs B from both sides then the battery retainer will easily slide out.
FIG.3
Being careful not to let the contents fall out, the battery retainer C
and batteries (if present) E will be easily removed.
Always follow the battery orientation guide D when installing 2 x AA
batteries E . Incorrect installation means the marker will not power
up or function.
B
A
C
E
D
FIG .1 FI G. 2
FIG .3
IMPORTANT!
ALWAYS use good quality AA batteries. DO NOT use rechargeable batteries.
Follow battery orientation guide on the battery housing.
To Next Page
Loading...
