receiving data over that port.
10 Green
rating at 10Mbps.
r
Lit: indicate that the port is ope
Blink: indicate that the switch is actively sending o
receiving data over that port.
ower Notice:
1. The device is a power-required device, it means, it will not work
2. In some area, installing a surge suppression device may also
2.2 Inst
ur Gigabit Ethernet Switch and
Note: This switch does not need software configuration.
2.2.1 Desktop Installation
To install the switch on desktop, simply follow the next steps:
Step1: Attach the rubber feet to the recessed areas on the bottom of
Step2: Place the switch on desktop near a DC power source.
Step3: Keep enough ventilation space between the switch and the
P
till it is powered. If your networks should active all the time, please
consider using UPS (Uninterrupted Power Supply) for your device.
It will prevent you from network data loss or network downtime.
help to protect your switch from being damaged by unregulated
surge or current to the Switch or the power adapter.
alling the Switch
This part describes how to install yo
make connections to it. Please read the following topics and perform
the procedures in the order being presented.
the switch.
surrounding objects.
To Next Page
Loading...
Need help?
General