Planet GSW-2401 - Installing a GSW-2401

6
7
Per 10/100/1000Mbps Port
LED Color Function
1000 Green Lights to indicate that the port is operating
at 1000 Mbps. Off to indicate that the port
is operating at 100Mbps or 10 Mbps.Blinks
to indicate the Switch is actively receiving or
sending the data over the port
10/100 Green/
Orange
Lights green to indicate that the port is oper-
ating at 100 Mbps. Lights orange to indicate
that the port is operating at 10 Mbps.Blinks
to indicate the Switch is actively receiving or
sending the data over the port
2.1.4 GSW-2401 Rear Panel
The rear panel of the Switch indicates an AC inlet power socket, which accepts input
power from 100 to 240VAC, 3.0A, 50-60Hz.
Figure 2-2 Rear Panel of GSW-2401
Power
Notice:
1. The device is a power-required device, it means, it will not
work till it is powered. If your networks should active all
the time, please consider using UPS (Uninterrupted Power
Supply) for your device. It will prevent you from network
data loss or network downtime.
2. In some area, installing a surge suppression device may
also help to protect your switch from being damaged by
unregulated surge or current to the Switch or the power
adapter.
2.2 Installing a GSW-2401
This part describes how to install your GSW-2401 Gigabit Ethernet Switch and make
connections to the Switch. Please read the following topics and perform the procedures
in the order being presented. PLANET GSW-2401 Gigabit Ethernet Switch do not need
software conguration. To install your GSW-2401 on a desktop or shelf, simply complete
the following steps.
2.2.1 Desktop Installation
To install a GSW-2401 on a desktop or shelf, simply complete the following steps: